If both engines are operating, a centered ball is zero sideslip.

If one engine is out, a centered ball will NOT be zero sideslip due to aerodynamic forces applied by the rudder.

1/2 ball width TOWARD the WORKING engine will achieve zero sideslip in a C310.

Zero sideslip yields the best control and the best performance (less form drag)

The left engine is critical (typically) because…

…P-Factor – Asymmetrical prop thrust on right (working) engine is further from centerline of the aircraft.

…Accellerated Slipstream – The working engine pushes air across the wing behind it. Due to p-factor, the right engine creates more lift on the outboard section of the right wing than the inboard, therefore rolling the aircraft left. Additionally, less down-force is produced by the tail, making the aircraft pitch down.

…Slipstream – the right engine's slipstream doesn't hit the tail (like the left engine's does), so it doesn't counteract any yawing moment.

…Torque – the engines turn to the right, rolling the aircraft to the left.

Published Vmc is marked as a red line on the airspeed indicator.

Actual Vmc changes with different factors, while published Vmc remains the same.

Published Vmc is close to the worst case scenario, actual Vmc may be lower, especially after feathering the inoperative engine’s propeller. Don’t bet your life on that fact, Vmc may be higher than you assume it is.

Vmc, as defined by 23.149 must not exceed 1.2 Vs1.

Vsse is the Single engine safety speed. This speed is slightly higher than published Vmc and creates a safety buffer from Vmc for intentional engine out operations. We should never fly the airplane below Vmc or Vsse, if published, under single-engine operations.

Why is directional control affected by airspeed? The faster the airspeed the more force the rudder can produce to resist the yawing tendency caused by asymmetrical thrust.

Vmc is the speed at which directional control can be maintained with one engine inoperative, under the following conditions…

• Standard atmosphere. (FAR 23.45)
• Most unfavorable CG and weight.
• Out of ground effect.
• Critical engine INOP
• Bank no more than 5° towards operating engine.
• Max available takeoff power on each engine initially
• Trimmed for takeoff.
• Wing flaps set to takeoff position.
• Cowl flaps set to takeoff position.
• Landing gear retracted.
• All propeller controls in takeoff position. (INOP engine windmilling)
• Rudder force required by the pilot to maintain control must not exceed 150 pounds.
• It must be possible to maintain heading ±°20